How to Tie an Egg Loop Knot for Fishing– Fishing Fetch

Fishingfetch
3 min readJun 21, 2023

--

Introduction

The egg loop knot is a popular knot among anglers, especially when fishing with bait such as salmon eggs or other soft baits. This knot is known for its ability to securely hold the bait in place while allowing for a natural presentation in the water. In this article, we will provide a step-by-step guide on how to tie an egg loop knot for fishing, ensuring you have a reliable knot for your next fishing expedition.

Materials Needed

Before we begin, make sure you have the following materials at hand:

  • Fishing line or leader material
  • A fishing hook
  • Bait (such as salmon eggs or other soft baits)
  • Scissors or line cutters

Step-by-Step Guide

Step 1: Prepare the Line

Start by cutting a length of fishing line or leader material to your desired length. The length will depend on your fishing setup and the size of the bait you intend to use. It’s generally recommended to have a line length of about 18–24 inches.

Step 2: Create a Loop

Take one end of the line and form a loop. The size of the loop will depend on the size of your bait. A good rule of thumb is to make a loop that is slightly larger than the diameter of the bait. Hold the loop with your thumb and index finger.

Step 3: Make Wraps

With the loop held between your thumb and index finger, start making wraps around the standing line and the loop. Make about 5–6 wraps in total. Keep the wraps tight and close together to ensure a secure knot.

Step 4: Pass the Tag End Through the Loop

After making the wraps, take the tag end of the line and pass it through the loop from back to front. Make sure to insert the tag end from the same side as the wraps.

Step 5: Create a Second Loop

Now, create a second loop by folding the tag end back towards the first loop. The size of the second loop should be smaller than the first loop. Hold the second loop with your thumb and index finger.

Step 6: Make Wraps Again

Similar to Step 3, make wraps around the standing line, the first loop, and the second loop. Again, make about 5–6 wraps in total, keeping them tight and close together.

Step 7: Pass the Tag End Through the Second Loop

After making the wraps, take the tag end and pass it through the second loop from back to front, just like in Step 4. Ensure that you insert the tag end from the same side as the wraps.

Step 8: Lubricate and Tighten

Before tightening the knot completely, apply some saliva or water to the knot. This will help lubricate the knot and reduce friction during tightening. Now, hold the standing line and the tag end, and carefully pull to tighten the knot. Make sure to pull both ends simultaneously to avoid any slippage.

Step 9: Trim Excess Line

Once the knot is tightened securely, use a pair of scissors or line cutters to trim the excess tag end close to the knot. Leave a small tag of about 1/4 inch for added security. Be careful not to cut the standing line or the wraps while trimming.

Conclusion

Mastering the egg loop knot is a valuable skill for any angler, especially when using soft baits. By following these step-by-step instructions, you can tie a reliable and secure egg loop knot for your fishing needs. Practice tying this knot, and you’ll be ready to present your bait effectively and increase your chances of landing that big catch. Happy fishing!

Visit the site — Fishingfetch

--

--

Fishingfetch
Fishingfetch

Written by Fishingfetch

How Should You Pass a Fishing Boat? – Tips & Strategies